Dryer takes two cycles to dry: the step-by-step check
Step 1: lint screen
Clean it every load. If water beads on the screen, dryer-sheet residue is blocking it; wash it with dish soap and a soft brush.
Step 2: the hose behind the dryer
Pull the dryer forward. A crushed or kinked foil hose cuts airflow sharply. Replace thin foil or vinyl hose with semi-rigid metal duct and keep it as short and straight as possible.
Step 3: the outside vent
Run the dryer and go outside. The flap should open fully and push strong, warm air. Weak air means lint is packed somewhere in the run. Garage laundry rooms and long runs to the roof collect the most.
Step 4: heat source
On electric dryers, one coil of the element can open while the other still heats, giving weak heat. On gas dryers, a weak or scattered burner flame gives the same result. Both need testing.
Step 5: moisture sensor
Sensor-dry cycles stop when the metal sensor bars inside the drum detect dry clothes. Residue on the bars can stop the cycle early. Wipe them with rubbing alcohol. If timed dry works but sensor dry does not, the sensor is the issue.
Slow drying is also a safety issue: lint in a restricted vent is a fire risk. Do not ignore it.
We check airflow and test the heat source and sensor on every call. See dryer repair in Studio City.